It is only when you know your home needs you will be able to choose the right type of Attic Insulation in Miami. Your choice will however depend on one of the most important factors, the R-value. Ideally, attic insulation, when done properly, will provide the best way to eliminate the chances of the heat escaping from the inside in winter and retain the cool air during the summer months. If your attic is leaking or drafty, it will cost you a lot of money. Therefore, you should use a thermal camera to conduct an energy audit in your attic to find the cool spots in your attic.
Know the R-value
If you cannot seal the holes then you will need to replace the entire Attic Insulation in Miami, depending on its age. This will prove to be more cost-effective and energy-efficient rather than filling the gaps in. The R-value of your home will depend on the location of your house. You will find everything about it from the Department of Energy. The R-value is the resistance value of the installation material to the heat flow. The higher the resistance value, more effective the insulating material will be. The R-value score will enable you to decide the type of insulation required for your attic.
Blanket insulation type
Once you know the R-value which should be between 30 to 49 per inch, you must consider the popular options for Attic Insulation in Miami, according to your affordability. The first type to choose is blanket insulation. This type of insulation comes in rolls and batts. This is also the best insulation material that allows DIY application. You will get this type of material in fiberglass, natural fibers, plastic fibers and mineral wool. However, you will need to trim the batts very carefully. This will allow a snug fit around the vents. This will maintain the effectiveness of the R-value.
Loose-fill insulation
This is another type of option used in Attic Insulation in Miami. This type on insulation is perfectly suitable for attics that have a very little headroom and several obstructions such as cross beams and vents. You can easily blow the insulation material over the current insulation. You will get this insulation material in three different types such as fiberglass, mineral wool, and cellulose. Out of these three, the cellulose is the most popular and effective because it has aR-value ranging from 2.2 to 3.8 per inch. However, there is one point of concern about this material. It can get moldy when it is exposed to moisture.
Spray foam insulation
If you can afford a bit expensive insulation for your attic then spray foam type insulation is the best option. It comes with the highest R-value at 3.5 per inch for open-cell insulation and 6.5 per inch for closed-cell insulation. This insulation material comes in polyurethane. The closed-cell foam cells are filled with gas, this helps it in expanding to fill in the space. One the other hand, the open-cell foam is filled with air giving it a spongy texture. However, this is not a DIY project. Visit Here: Atlas Insulation
Insulation Miami | Atlas Insulation (305) 858-3155 